PangeaDestructor
Active member
Sorry if this isn't the right forum, I can move if so. Been staring at this mess for an hour now, and not for the first time. I probably do it once a week. I keep looking at it for a while and getting close, then going "nope, not today." Ignore the missing diodes on the pedalpcb intelligent relay bypass, i have those here and will add them later today. Jacks and power will be at the top, and to help with the power i have the DC jack breakout board. To complicate things further, I'd like to try and cram the pedalpcb order switcher in here, close to the top at the center right beneath the DC jack. Box is a tall version 1590bb, so there should be enough vertical space.
What we've got here is a modded green russian built on a guitarpcb muff'n fuzz, with the clipping, tonebender, LP/HP and mids control mods. This is going to be controlled by the buff n' blend right below it, which includes a clean blend pot. I've tested this board and it sounds great.
Next door is a Squidward (currently upside down for some reason), controlled by (a) the intelligent relay bypass, so that it has momentary and latching function, and (b) a Mask Audio jfet blender (https://maskaudioelectronics.com/products/utility-blender) to blend in and control the amount of octave. I'll probably wrap the squid in something non-conductive to keep it from shorting or bouncing around too much in there.
I emailed Alec at Mask about how to wire up the blender here, and he said "The send and return on the blender would go to the in and out of the octave, the input of the blender would be the input of the pedal and the output of the blender would be to the input of the muff." This is more or less clear to me, but when you throw in the footswitch boards and - possibly - an order switcher, I start going cross-eyed again.
I cannot for the life of me organize where to make each of the connections, so if anyone has nothing better to do and wants to help out with either written help or some ms-paint style markups of the attached pics, I'd love any support I can get on this. Included a pic of the enclosure top in case it's helpful to try and visualize hopefully the end result.
What we've got here is a modded green russian built on a guitarpcb muff'n fuzz, with the clipping, tonebender, LP/HP and mids control mods. This is going to be controlled by the buff n' blend right below it, which includes a clean blend pot. I've tested this board and it sounds great.
Next door is a Squidward (currently upside down for some reason), controlled by (a) the intelligent relay bypass, so that it has momentary and latching function, and (b) a Mask Audio jfet blender (https://maskaudioelectronics.com/products/utility-blender) to blend in and control the amount of octave. I'll probably wrap the squid in something non-conductive to keep it from shorting or bouncing around too much in there.
I emailed Alec at Mask about how to wire up the blender here, and he said "The send and return on the blender would go to the in and out of the octave, the input of the blender would be the input of the pedal and the output of the blender would be to the input of the muff." This is more or less clear to me, but when you throw in the footswitch boards and - possibly - an order switcher, I start going cross-eyed again.
I cannot for the life of me organize where to make each of the connections, so if anyone has nothing better to do and wants to help out with either written help or some ms-paint style markups of the attached pics, I'd love any support I can get on this. Included a pic of the enclosure top in case it's helpful to try and visualize hopefully the end result.
Attachments
Last edited: