Help Wiring 2 Pedals Together

[850special]

I built a big muff clone (BYOC Large Beaver) years ago and would like to wire it up to a Muroidea build in one box. I’d like to have one input and one output, have both pedals be independently selectable, and have a toggle switch to change order (rat->muff, or muff->rat).

Any guidance on doing this? Thanks!

 

[Robert]

You can hand-wire the order switch, or you can use a breakout board.

3PDT Order Switch - PedalPCB.com

3PDT Effects Order Switcher

www.pedalpcb.com

Rotary Order Switch - PedalPCB.com

Rotary Effects Order Switcher

www.pedalpcb.com

Here's the overall wiring diagram using breakout boards:

You can, of course, hand wire the entire thing if you'd prefer to not use breakout boards.

 

[850special]

Thanks, very helpful. The BYOC board numbers their footswitch connectors (2, 1, 5, 4, 7, 8). Any ideas on that numbering and how it would equate to the breakout boards above?

 

[pricklyrobot]

That numbering on the BYOC PCB corresponds to what lug of the 3PDT it attaches to:
1 • 4 • 7
2 • 5 • 8
3 • 6 • 9

From L to R on your PCB, I think it should be…
2: Ground/-
1: LED Cathode/-
5: Board In
4: Jack In
7: Board Out
8: Jack Out