Hydra Delay

djmiyta

Well-known member
Shit ! Stupid me did NOT read the build docs 1st. Had I done so I MAY have noticed the call for 1/8 watt resistors. Key word here MAY. Hennyways is it possible to build this pedal using standing 1/4 watt resistors ? hoping to hear something like..." yeah person who should read build docs prior to ordering, its doable". Anybody? Dont have the board yet , but my glass is filled to rim with optimism . Damn you Mr. Pedal PCB for not having bold flashing neon print clearly telling all (probably just me) of this enigma I now possibly could be facing maybe. (I've learned to deflect ownership and responsibility when I'm wrong(ed) and my mom and grandma say they are fine and rare qualities to find in young men these days.) As if I need ANY justification for my rant. Am I right? My mom thinks so!
 
1/4 watt is higher rated than 1/8 watt, you should be fine. resistor wattage rating is how much energy it can take before it pops, essentially
now, if you had 1/8's and it called for 1/4's you'd be out of luck.
 
I built it with 1/4 watt resistors. It's not an issue IMO. I bend one the legs along with the body of the resistor and leave the other one as is, it's pretty easy to solder them standing. I don't think the space caused any issues.
 
Fantaboulous I was gonna make it happen no matter what ,but a little verification never hurts too much, thanks for the "go get 'em sport" positive vibes. Cause that's what I'm hearing. Thanks again for the input.
 
I did not like doing it because I couldn't easily bend them consistently (too lazy). With the other 1/4W footprints, the resistors almost snap into place (and stay there!) if you pull the leads from the back side of the board after a quick bend with your fingers.
 
Funny when I first started building and looking for layouts I'd come across layouts that had standing resistors and passed on building any of them ( when on occasion I have to add 1 or more overlooked resistor to a build they always look haphazardly put in) By looking at yours looks really nice. Is the trick to solder the 1st lead in super flush with board then bend the other in keeping it taut as its soldered in? It 'd take me an extra day to get mine looking that nice
 
Back
Top