Incorporating the Intelligent Relay Bypass with an AionFX board

[KR Sound]

I’m wanting to use the Intelligent Relay Bypass in this AionFX Onyx and I think I have a plan but I’d like to get some other eyes on it.

His breakout board has the three areas for in, out, and power and I assume it’s just a matter of wiring those up where I’ve drawn them here:




Here’s his schematic and breakout:

 

[benny_profane]

I’d pull the daughter board power from the V+ connection (i.e., after the diode and filtering) by wrapping a wire around an exposed bit of the joint rather than bypassing it as you have now.

The order is changed with the I/O connections, but it’s series so that shouldn’t be an issue.

You’ll need a CLR for the LED and to ensure it’s oriented properly.

 

[KR Sound]

I’d pull the daughter board power from the V+ connection (i.e., after the diode and filtering) by wrapping a wire around an exposed bit of the joint rather than bypassing it as you have now.

The order is changed with the I/O connections, but it’s series so that shouldn’t be an issue.

You’ll need a CLR for the LED and to ensure it’s oriented properly.

I was thinking that it really didn’t matter since the Relay board has its own diode and filter cap. Wouldn’t hurt I guess?

 

[benny_profane]

I was thinking that it really didn’t matter since the Relay board has its own diode and filter cap. Wouldn’t hurt I guess?

Ah you’re correct. I missed that when I revisited the project page. Your initial power scheme is fine in that case.

 

[KR Sound]

Ah you’re correct. I missed that when I revisited the project page. Your initial power scheme is fine in that case.

Sweet. I’ll try to hook it up later this evening and see how it works.