Intelligent Relay Channel Switch pop

[DGWVI]

I've searched, but haven't found anything. I'm using the Intelligent Relays in my triple Rat set for channel switching. Its silent when bypassing or engaging any of the three, but I get a significant pop when swapping from one channel to the next. All six circuits have their own 47r current limiter to the 9v supply. Pop happens regardless of placement or power supply

Just wondering if there's a way to eliminate or mitigate the popping when switching channels

 

[Robert]

Hmm.... If it's happening when switching between channels but not when toggling a single channel on/off it might be because there is a brief instant where both circuits are active when switching between channels.

Maybe we should delay turning on the newly activated channel by a few ms to give the now-disabled channel time to completely transition to bypass.

Three modules in your pedal, correct?

 

[DGWVI]

Hmm.... If it's happening when switching between channels but not when toggling a single channel on/off it might be because there is a brief instant where both circuits are active when switching between channels.

Maybe we should delay turning on the newly activated channel by a few ms to give the now-disabled channel time to completely transition to bypass.

That makes sense. I'm guessing the eeproms would need to be reprogrammed to add a slight delay?

Three modules in your pedal, correct?

Yep- three bypass modules, three Rats / Triads