Issues with Bootleg

[jstecks]

Hi all,

I'm struggling to get this Bootleg to work properly. For a little while, it was sorta working (something sounded off with the biasing I think) when the switch was in the down position (pointing towards the PCB) and with the blend knob (10k pot) all the way down.

Any suggestions? I have tried reflowing the joints and haven't had any luck yet.

Thanks

 

[dcfvgb]

Have you measured the voltages? Anywhere on the schematic it shows Vref should be approx 9V.

 

[jwin615]

Hard to tell but IC1 legs look off.
Also, make sure you didn't mix up nF and uF with all those MLCCs

 

[Strat68]

Several things you may have already tried. Brush off all the, what looks like solder dust. Make sure all the ICs are full inserted into the socket. I have had that problem. I thought they were in but push them some more to see. I sometimes get ICs that are more deeply inserted on one side than the other.