I just wrapped up a kliche mini, and it sounds good in bypass. When I click it on the volume and tone work but there is no gain. When I roll it off it kills the signal, but there’s no drive when you push it. Any idea where the problem may be?
It is hard to tell from the picture, but it looks like the wire to the footswitch are reversed on the top side of the image. The middle and right lugs look switched, but that could just be the image.
Must be crossed under the board, because the image looks like the top outside pin of the board is going to the middle lug of the foot switch and not to the far right. Maybe post an image looking at it from the other side?
