chongmagic
Well-known member
Not sure if I am sharing this correctly or not, but just quickly put together a template for the new version of the L5 Preamp, just wanted to see if someone would check over this to see if it looks correct?
1590XX L5 Preamp Drill Template - New Version DC Power
- Thread starter chongmagic
- Start date
Band of Dans
Well-known member
I haven't ordered it yet, so this is just my interpretation of the Aion build docs, but here's mine. It's unfortunately rotated 180 degrees from yours. The only difference I see right off the bat is the in/out/9v jacks are a bit lower on mine. I think that was a guesstimate that erred on the side of leaving more room for clearing the board or may have gone off this discussion in another thread.
chongmagic
Well-known member
I haven't ordered it yet, so this is just my interpretation of the Aion build docs, but here's mine. It's unfortunately rotated 180 degrees from yours. The only difference I see right off the bat is the in/out/9v jacks are a bit lower on mine. I think that was a guesstimate that erred on the side of leaving more room for clearing the board or may have gone off this discussion in another thread.
That is a great idea on the jacks being lowered. This is the first time I have attempted to use the drill tool, I just wanted to see if I could get some extra eyes on it.
Audandash
Well-known member
So i havent looked over everything yet but band of Dans is correct on the jacks. Make your x coordinate for them +5. That will allow enough space for clearance and allow you to use most any type of jacks. That is the spacing I use on all of the Aionfx 1590xx boxes.