mattb33
New member
- Build Rating
- 5.00 star(s)
What an amazingly fun fuzz.
This post is partly because the design has a forum-specific reference to fig that no-one else would get, but mostly to sing the praises of @szukalski - for not only the Figbuster PCB, but for open-sourcing the relay board as well - it got me going down the rabbit hole of relays, SMD board fabrication and designing PCBs.
The insides are nothing special - upside-down caps don't phase me. I did realise after the fact that I could have used pin headers to connect the relay board to the main board, so I'll try that if I make a few of these for friends.
Shout-out to @music6000 for the circuit as well.
Enclosure & UV-printing via Tayda.
This post is partly because the design has a forum-specific reference to fig that no-one else would get, but mostly to sing the praises of @szukalski - for not only the Figbuster PCB, but for open-sourcing the relay board as well - it got me going down the rabbit hole of relays, SMD board fabrication and designing PCBs.
The insides are nothing special - upside-down caps don't phase me. I did realise after the fact that I could have used pin headers to connect the relay board to the main board, so I'll try that if I make a few of these for friends.
Shout-out to @music6000 for the circuit as well.
Enclosure & UV-printing via Tayda.