Well, to finish a long arduous project called fuck it up some more I lifted the pads on the Hydra for the LED and for the 4k7 R13 resistor to the LED. I have bridged the anode of the Diode D1 to the anode of the LED. I haven't done anything with the Cathode yet. Trying to figure where to tie it in.
Now, I noticed I'm not getting any voltage on the PCB out to the switch marked SW on the pcb. Suspect that I'm going to have to bridge that. I have seen various diagrams on where to connect the LED to the switch, but I am curious about what to do with the SW out to the 3PDT. even with a mag glass I can't follow the trace for it. Where should I jumper PCB SW from to route to the 3PDT and where should the Cathode on the LED go on the 3PDT.
thanks in advance
Now, I noticed I'm not getting any voltage on the PCB out to the switch marked SW on the pcb. Suspect that I'm going to have to bridge that. I have seen various diagrams on where to connect the LED to the switch, but I am curious about what to do with the SW out to the 3PDT. even with a mag glass I can't follow the trace for it. Where should I jumper PCB SW from to route to the 3PDT and where should the Cathode on the LED go on the 3PDT.
thanks in advance
