Low Tide - no wet signal

[fontoponto]

Hello everyone,

I assembled a Low Tide and now there is no wet signal. The last point where I can hear with the audioprobe is at R8 and then the clean again at the Mix pot.

Voltage file attached that I happily stole from another thread...

Measured with
Rate Max
Gate 12:00
Slew Min
Mix Max
Depth Max
Level Max
Boost Off
Pad Off
Trim BDD 12:45
Trim Gate 12:00

As 2SK208-Y I used the SMT variant also a J201.
Fairchild J201 THT and MMBFJ201 (unkown company)
Cool Audio V3207D
The resistor and cap values are according to the manual. I rechecked all resistors a few minutes ago by color code.

Any suggestions?

 

[fontoponto]

Sorry I had to leave without writing down what I already did… Will update later.

 

[fontoponto]

IC4,LM258P,1,OUT1 --> 0,58V looks like I did not use the gate trimmer correctly...
Now I can hear the wet signal!

 

[fontoponto]

Low Tide - Almost Working. Help?

Howdy partners. I am not a circuitry genius like it seems like a lot of people online are. Perhaps I am not skilled enough to finish this but I think with a few nudges this can be figured out. I have built quite a few pedals and troubleshot a bunch on my own but I am just not sure what to do...

forum.pedalpcb.com

It would be nice to have this in the build documentation

 

[KR Sound]

Low Tide - Almost Working. Help?

Howdy partners. I am not a circuitry genius like it seems like a lot of people online are. Perhaps I am not skilled enough to finish this but I think with a few nudges this can be figured out. I have built quite a few pedals and troubleshot a bunch on my own but I am just not sure what to do...

forum.pedalpcb.com

It would be nice to have this in the build documentation

That would make it too easy