Magnetron LEDs not working

[nichgriff]

Hello!

Back again with another stupid question!

Both LEDs aren’t working on my magnetron delay. They were both working when I had them setting in place testing the circuit but neither work now that they are actually in the enclosure. Assuming it is likely being sent to ground somewhere (like my last issue) but can’t solve this one as easily as the last one.

Any thoughts? Confirmed no bridges between SW and ground. LEDs are oriented correctly. Both worked pre-enclosure. Tried swapping them out with no luck.

 

[nichgriff]

So weird thing - I did remember I switched colors of LED and apparently I have a whole batch of yellow LEDs that do not work. Welp. Red is good to go though!