Thommo
New member
G'day folks,
Just after some clarification on which way to solder the dip switches and header pins to the break out board.
on the silk screen side or the back side?
I'm going to have the dip switches external.
I'm getting a bit confused with the labelling being opposite from the faceplate to the dip board.
Or does it not matter because of where the header pins go into the main PCB?
Cheers,
Thommo.
Just after some clarification on which way to solder the dip switches and header pins to the break out board.
on the silk screen side or the back side?
I'm going to have the dip switches external.
I'm getting a bit confused with the labelling being opposite from the faceplate to the dip board.
Or does it not matter because of where the header pins go into the main PCB?
Cheers,
Thommo.