Purchased a kit from StompBoxParts using the Muroidea pcb for a rodent pedal. Nice kit, btw.
Anyway built it all up and got no signal coming out of jack output with switch enabled.
Built an audio probe to troubleshoot the circuit.
Looks like to me, as an intermediate skill level builder, that the diagram MAY be incorrect.
Page 5 shows the overall layout of the pedal with the jack input on the left or volume side of the pedal.
Page 4 shows the petal from the bottom view with the wiring from the jacks to the switch. From the bottom view the input jack would be reversed or on the right side
and that signal is running to the switch and then to the 'out' on the PCB. Don't seem right to me.
Anywho, switched my input signal to the other jack, and voila.... everthing works.
Maybe someone can verify, validate for future users/buyers, revise the schematic.
joe
Anyway built it all up and got no signal coming out of jack output with switch enabled.
Built an audio probe to troubleshoot the circuit.
Looks like to me, as an intermediate skill level builder, that the diagram MAY be incorrect.
Page 5 shows the overall layout of the pedal with the jack input on the left or volume side of the pedal.
Page 4 shows the petal from the bottom view with the wiring from the jacks to the switch. From the bottom view the input jack would be reversed or on the right side
and that signal is running to the switch and then to the 'out' on the PCB. Don't seem right to me.
Anywho, switched my input signal to the other jack, and voila.... everthing works.
Maybe someone can verify, validate for future users/buyers, revise the schematic.
joe
