Notakliche switch question

[mjcyates]

I am building a NOTAKLICHE and in doing so had an issue that resulted in me lifting the traces on the WDJD switch. Because of this I need to hardwire the switch lugs to the appropriate components. I am having difficulties tracing exactly what needs to be wired to what and was wondering if someone could post a diagram of some sort that would show which lug needs to be wired to which component. Thanks.

 

[Feral Feline]

Did you ever get this sorted out, @mjcyates ?


I recall another thread with this problem, hmm not exactly, different circuit.

Lifted pads

So….it happened. I soldered pots on in wrong direction, cussed for 10 minutes straight, then sat down to fix the problem. Cussed for 10 more minutes when I saw that I lifted two pads de-soldering. So jumper wires? On the back of the PCB it looks like square pad goes to next pots rightmost post...

forum.pedalpcb.com

Another thread had a partial schematic (but has the bit you need):

Notakliche bits

Hey all, I'm hoping to finish off a notakliche feeding into an uberdrive this weekend, and just have a couple of questions. I'm looking to use bat41 for the main diodes at the bottom of the PCB - I can see the PCB is labeled with a stripe for what I assume is the cathode - although I also read...

forum.pedalpcb.com

Post some pics of your build, so it can be determined which traces were lifted, if not all.

 

[mjcyates]

Thanks for your reply. No I have not gotten it sorted out. I tried a fix based on what I could determine and it didn't work so currently it is on the shelf. I will get back to it at some point.