PedalPCB Rockman?

andrewsrea

andrewsrea

Well-known member
Does PedalPCB have a build something like the MXR Rockman X100 pedal?

My 'sound ' from 1987 to 1992 was a Rockman Sustainer Preamp into a Marshall Jubilee 2553 (small box 50w). Both have long been out of my fold. It was a pretty dated sound, but every once in a while I am nostalgic to jam on that tone.
 
The PedalPCB "Proposition Distortion" will get you partway there, distortion side anyway. My "as-builts" were never finished enough to share, but I did a two stripboard versions of parts of the circuit. I would like breadboard another version putting together some ideas/circuits from this forum, but not enough hours in the day. I know the sustainer is another level of complexity, but those were awesome.
 
PPCB has no full featured X100 project board. As @MarginalPlayer points out, PPCB's "Proposition" is a buffer-less Rockman Ultimatum pedal; which has the same distortion ranges, when so dialed in can match the EDGE or DIST, as the X100. But none of the CHORUS or ECHO effect.

For those enterprising enough, a thread is posted the ToolBox forum: "Rockman X100 Rev. 10 Schematic Release", laying bare the schematics of the 2 main boards & daughterboards for a fully pedal capable X100.
 
You must log in or register to reply here.
Back
Top