Peppermint fuzz
- Thread starter K Pedals
- Start date
Nostradoomus
Well-known member
Jumper from 1-2 of the clean trimmer pads
Replace R2 with a 100K trimmer
Jumper R3
R4 1k
Make the sundial pot 25K
3.3k resistor across 1-3 of the bias pot pads
I didn’t watch the video but that will get you most of the way there assuming this schematic is the right one
Replace R2 with a 100K trimmer
Jumper R3
R4 1k
Make the sundial pot 25K
3.3k resistor across 1-3 of the bias pot pads
I didn’t watch the video but that will get you most of the way there assuming this schematic is the right one
Nostradoomus
Well-known member
Oh. Could save a step and just run the 3.3k across here.
