plaid preamp pots -- board says differnt things on different sides

[!obey]

I'm getting around this morning to installing pots in a plaid preamp.


The board silkscreen lists the treble/mid/bass pots as A100K, B25K, A1M, respectively, on the component side. This is typically what I use to identify what's needed, and the build docs aren't posted yet to check.
However, the treble/bass values don't match the silkscreen value on the board's reverse.
E.g., the physical holes for the treble pot say A100K on one side of the board and A1M on the other.
Which is the right one to follow?

 

[Cybercow]

Considering that the PCB is mirror-imaged when it is flipped over, has that been taken into account?

 

[!obey]

(lol... i'm familiar with orientation in three dimensions... and i don't remember taking any drugs this morning. i promise i took it into account).
what i mean is that holes that go through the board are labeled differently on the silkscreens on different sides of the board.

e.g the treble pot mount is on the left side of the component side of board and is labeled A100K. when i flip the board over, that mount is on the right side of the board but the label then says A1M. (when i put an A100K in the holes, the other side shows it installed in a slot labeled A1M)

 

[Robert]

Follow the silkscreen on the component side.

The values on the potentiometer side should have been marked out but a few might have slipped out before I caught it.

 

[!obey]

thanks! i felt it safer to ask a dumb question than risk butchering the removal of the wrong pot.

 

[Jonnytexas]

Came to post same thing. Just so I'm clear, the treble is is an A100k?

 

[Jonnytexas]

Buehler Buehler Buehler

 

[Barry]

Came to post same thing. Just so I'm clear, the treble is is an A100k?

Yes

 

[Jonnytexas]

Yes

Thanks for the reply.