Radium Springs, Low output when effect is on.

aienco

Member
I just finished my Radium Springs. I have followed a couple of other threads where this has been discussed with no real final outcome/fix? My output is almost halfed if I have full mix and max volume when the effect is switched in. It works as it should, just lower output. Comparing my board to theirs, I noticed my board states B10K and the docs state B100k on the mix. I tried both. Did not really notice a heap of differece. My Board is a V3. I have double checked my resister values and caps. I have replaced the two op amps just in case. I have resoldered all joints. I have low volume and have no idea how to increase it! Perhaps this is the way it is meant to be, but I am just trying to clarify I guess.
 

Attachments

  • 20230212_113626.jpg
    20230212_113626.jpg
    1.3 MB · Views: 22
Back
Top