Sag control on basic fuzz face

[ac30irons]

Hey all , is there a way to add a sag control to a basic fuzz face. I’m breaking out the bias but am just wondering if the other is possible.

Thanks in advance.

 

[Feral Feline]

Yes, it is doable.

There are a number of ways to it being doable, but I'll suggest taking a look at the Chop Shop (Barbershop).

Check the Fuzz Foundry as well.

 

[ac30irons]

Yes, it is doable.

There are a number of ways to it being doable, but I'll suggest taking a look at the Chop Shop (Barbershop).

Check the Fuzz Foundry as well.

Thanks for the reply. I can see it’s putting B10K in but where and how would I implement that on the fuzz face ?

 

[MobyOctopad]

I'll preface this by saying I'm never sure what I'm doing when it comes to the hobby, but could you add the pot at the end of the power section like Aion in their take on the Fuzz Factory? Assuming you were thinking of adding it to an NPN Fuzz Face, not sure how different things would be dealing with a voltage inverter if you had a PNP build in mind.

All that said, I'd wait for someone who actually knows what they're doing to weigh in.