Simms-Watts AP100 mkII 1972

New PT and 4H choke with 400mA rating arrived today, but pity me about figuring PT lead as no tap markings on this one. DC resistance readings only confused, because secondary has HV taps with bias and center tap there too.

I know I could power it with low AC trough another trafo, but there’s also extra lead on supposed primary side and I’m not sure what it is. That lead wasn’t mentioned on specs. Shield maybe?

So only choke goes in today and gonna email Uraltone about color coding on PT leads. Better to be safe than sorry.
 
Okay, choke went in as planned and when I was chassis open had a thought to add ceramic 100pf bypass caps for V1 anode resistor. It helped with excessive hiss taming and the choke tamed down 50Hz hum FINALLY, but there wasn’t such thing as free lunch here. Hiss and 50Hz hum were masking 150Hz hum which came audible. Thats’s for sure better than the rumble I had earlier.

Did some freq analyzing with my phone yeasterday (good typo, won’t fix it!) after rehearsals. Channel volume or master down the amp is completely silent, but as soon either is opened the 150Hz creeps more audible as pot is turned.

IMG_8801.png

This volume pot turning led me to realize, I’ve made a mistake with grounding stages for their own separate stars. I’ve not followed hooking grid leak resistor gnd side to stages cathode on preamp. Neither with vol&tone pots. Gonna fix that next!

Also choke did gooood, amp is meaner than ever and low chord transients really push air.
 
Saga of The hum which bothers continues!

Most recent tweaks:
  • Redid input stages component layout, changed vol pots for sturdier ones, used twisted pairs in/out from pots and made sure things on grid are referenced to following cathode.
  • Changed B+ dropping resistor strings values to 15/22/22 kOhm and it alonr raised filament elevation to ~ 43VDC. More gain on preamp too.
  • Looked along B+ resistor/cap junctions with DMM for AC ripple. Cap before choke had 10-20mV, but after choke barely detectable and readings were either under 10mV or no reading at all.
Results:
​
50Hz - I think this is mostly solved. Speaker cone isn’t vibrating anymore, not even when dimed and inputs shorted.​
​
100/150Hz - lowered, but gets more audible if feedback amount (variable on pot) is reduced. I have it more there than Model T has. 15K resistor and 100K pot on OT sec speaker lead feeding 4.7K on PI. 5-10% turn from potentiometers min setting immediately brings more hum in.​
​
Hiss - it comes in naturally if channel volume is raised input shorted. It was canceled before with lower freqs and now it drowns 150Hz away.​
​
Suspect to rule out:

Rectifying has ultra fast soft recovery diodes, but haven’t tried snubbing ’em with diodes with RC parallel. Maybe try 47r+10nF parallel with each diode? Do you have any suggestions on snubber values?​
 
You must log in or register to reply here.
Back
Top