SMD to TO-92 PCB question.

[JBoss]

Hey ya'll.

So I bought the SMD Transistor to TO-92 PCB's from Tayda. I noticed that the markings for Gain, Source, and Drain, are reversed on these. Will I need to adjust the way I place them onto the pin headers because of this?

Thanks!

 

[temol]

If the Source is in the middle it's ok.

 

[phi1]

What do you mean they are reversed? I just took a peek at the pcb image vs the j201 datasheet... looks right to me (D labeled hole on the little pcb connects to D pad of the smd j201.

Did you check out the instructions link on the tayda pcb page? Looks like it’s pretty informative.

 

[JBoss]

What do you mean they are reversed? I just took a peek at the pcb image vs the j201 datasheet... looks right to me (D labeled hole on the little pcb connects to D pad of the smd j201.

Did you check out the instructions link on the tayda pcb page? Looks like it’s pretty informative.

Hey phi1, my brain was kind of spaced out yesterday, should've taken a better look! Thanks for the help!