Finishing up my build and I noticed that the ground and hot wires for the power at the top aren't marked in any way on my board and neither are the circuit in/circuit out pads on the bottom. It's not addressed in the BOM and there's no schematic so I can't even follow the trace to figure it out on my own. Did anyone else have this prob and how did you get around it?
Super heterodyne receiver missing pcb labels?
- Thread starter Jonathan
- Start date
Robert
Reverse Engineer
At the top, the two center pads are + / - respectively. The two off to each side (at the top) are grounds for the In / Out jacks.
At the bottom the pads are IN/GND/SW/OUT. Aside from the board looking different, you can follow the standard wiring diagram.
At the bottom the pads are IN/GND/SW/OUT. Aside from the board looking different, you can follow the standard wiring diagram.
