THAT4301 overhanging

[jackttfg]

Hey guys,
was just about to start my muzzle build when i realised that the THAT4301 module overhangs into the IC1 slot.
Any ideas how i can make this work/ am i doing it wrong?

 

[fig]

You need two rows of female header pins.

40 Pin 2.54mm Single Row Female Pin Header

GTK - Get It Fast - Same Day Shipping

www.taydaelectronics.com

Can't see it here, but you can see that it clears the chip.

Here is a Terrarium, but with the headers.

 

[Robert]

You can either use a pair of female headers like Fig mentioned, or you can use a 20-pin DIP socket along with round pin male headers.

You want the round pin male headers if you use a socket because the standard square pins are a bit too thick for IC sockets.

20 pin DIP IC Socket Adaptor Solder Type

Lead Free - Get It Fast - Same Day Shipping

www.taydaelectronics.com

40 Pin Male 2.54mm Single Row Pin Header Break away Round Pin Gold Plated

Get It Fast - Same Day Shipping

www.taydaelectronics.com

 

[Steve973]

I want a Muzzle board so bad! I'll be buying one (and the THAT4301) as soon as they are available!

 

[Paradox916]

THAT4301 RetroFit Module

Well this isn’t really a build report per se as I used an existing muzzle build to note any differences between the actual 4301 and the retrofit with 4305.... hers is the skinny on what I experienced.. the module using 2.54mm pin headers sits about the same as the 4301 In a IC socket and a few...

forum.pedalpcb.com

Not sure if this helps you at all