Chuck D. Bones
Circuit Wizard
Have you powered it up?
This Week on the Breadboard: A Stereo Digital Reverb
- Thread starter Chuck D. Bones
- Start date
cooder
Well-known member
Not yet haven't had time time do more on it.
szukalski
Well-known member
Chuck - in the T60 there was a mode switch, which influenced the size switch, did you try this out (and have an opinion)?
I am putting this onto the backlog, with the initial idea to use a TL072 instead of the TL071 and using the spare opamp for summing the output in a switched mono mode.
I am putting this onto the backlog, with the initial idea to use a TL072 instead of the TL071 and using the spare opamp for summing the output in a switched mono mode.
Chuck D. Bones
Circuit Wizard
I tried the MODE switch. Did not find it to be very useful. I also learned that we don't need a dual pot for SIZE. A single pot can vary the VCO freq for both delay chips with no noticeable interaction.
If you only want a mono output, then you can use one opamp to mix the two REV outputs and the dry signal. One TL072 will take care of everything.
If you only want a mono output, then you can use one opamp to mix the two REV outputs and the dry signal. One TL072 will take care of everything.
passtheducky
Active member
It must go Hhhhwwwwwrrrrggggg when you change the size.
Chuck D. Bones
Circuit Wizard
Uh huh, just like any other PT2399 circuit.
