Tommy in a 1590b

kungpow!

kungpow!

New member
I can't find a single one on the forum. It is possible! I dont like 125b. I discovered that the infamous Dano transparent overdrive v1 sounds fantastic in my jcm 800 studio. Didnt want to pay the bucks for a v2. I dont like mini pedals, so the mxr was out. I sanded down the sides of the pcb to get the width to fit. I intended for the jacks to go low by the footswitch, but after the board and footswitch got in there, up high was the only place left. Same goes for the clipping toggle. Sounds great, slightly different to the Dano, more flat and transparent. I used lm1458.
20260502_113407.jpg
20260502_113542.jpg
20260424_173731.jpg
 
Last edited:
Another way to get some PCBs of this width to fit in a 1590B is to solder just the tip of the pot legs into the PCB. I've done this recently with some other PCBs and it works. Instead of soldering the pot legs into the PCB as far as they will go solder them when the tip of the leg only just pokes through - maybe a half millimetre.

BTW if you make the hole for the DC jack closer to the top of the enclosure you can fit the jacks into the end of the box too.
 
You must log in or register to reply here.
Back
Top