Trembling Loon

[GAStan]

Build Rating

5.00 star(s)

Another Lune. Built per documentation, no intentional mods other than status LED location. Did have to file the leads on a couple of pots for the 5mm Rate LED housing I chose, shown in the photos. Tayda drilled and UV printed enclosure. Artwork was freely downloaded .png image that I worked on a bit. If I do this again I'll mirror the Loon and use a 3mm Rate LED for its eye.

 

[Caedarn]

Nice!! You're far braver than I am squeezing that LED bezel between those pot legs!

 

[GAStan]

Nice!! You're far braver than I am squeezing that LED bezel between those pot legs!

Thanks!! However that was more due to poor planning than anything else. The bezel needs an 8mm hole which was drilled by Tayda so I had to work with it. Luckily the legs were wide enough to do what I did. A Dremel would have made short work of it but I just used a fine tooth file.

If anyone ever does this be mindful of the filings, they can make the pot nearly unusable if they get inside it. Tape is your friend.