fank.brack
New member
Hi all, just had a quick question on troubleshooting. I bread boarded a big muff to check out the different revisions before I soldered it up. I'm getting a good gain boost out of the first transistor stage. But in the clipping stages, I'm getting a high pass for each, and very little clipping. I've rebuilt it a couple of times, and checked voltages at the collectors, but I can't seem to figure out what I'm muffed up.
Is there something beginner/simple I could have messed up that would cause a significant cut of low end freq in the gain stages of a muff circuit?
Is there something beginner/simple I could have messed up that would cause a significant cut of low end freq in the gain stages of a muff circuit?