Tubular Overdrive (Valve Stem)

[SYLV9ST9R]

Just finished this one.
A really nice and crunchy OD with lots of tone shaping controls.

Only thing I added was a relay bypass.
It did get crowded in there, had to change the enclosed jacks I had for Lumbergs I took from a pedal that needs some troubleshooting.

There was a misalignment with the gloss varnish on the UV print, but it still looks good and gives it a bit of a 3D effect.

 

[fig]

Great work! The knobs set it off. It looks like the relay and main board lined up well.

 

[SYLV9ST9R]

Great work! The knobs set it off. It looks like the relay and main board lined up well.

Thanks! I used pin headers, and it was a nice fit.
It’s a tad high for a 1590BB, but the lid only pushes lightly on the footswitch connector.
I was worried about the bigger knobs, but they fit just right to operate nicely.

 

[finebyfine]

Looks awesome! Love the different knob sizes.

 

[wintercept]

I really dig the art and the knob choice.

The inside is nice and tidy too. Great build!

 

[SYLV9ST9R]

Looks awesome! Love the different knob sizes.

Thanks! Those chunky boys are nice!

I really dig the art and the knob choice.

The inside is nice and tidy too. Great build!

Thanks!