F Fr4nck New member May 19, 2019 #1 Hello, I'm building one of PedalPCB kit and I have bugs.... I try to find where. To eliminate any possible errors, I'm asking to you "how do you know where the + and the - on the jacks if you don't buy the same ones?" Thank you Last edited: May 19, 2019
Hello, I'm building one of PedalPCB kit and I have bugs.... I try to find where. To eliminate any possible errors, I'm asking to you "how do you know where the + and the - on the jacks if you don't buy the same ones?" Thank you
Robert Reverse Engineer May 19, 2019 #2 You can use a DMM to measure continuity. The negative terminal connects to the center pin in the jack. On this type the positive lead is the longer terminal.
You can use a DMM to measure continuity. The negative terminal connects to the center pin in the jack. On this type the positive lead is the longer terminal.
F Fr4nck New member May 19, 2019 #3 oh thank you but it was about audio jack In and out jack are boxed, and we can't see witch part of the 6.35 Jack is connected with standards models
oh thank you but it was about audio jack In and out jack are boxed, and we can't see witch part of the 6.35 Jack is connected with standards models
Robert Reverse Engineer May 19, 2019 #4 Otherwise you can plug in a cable and measure between the lugs and the cable with a DMM.
