Latest activity

I am a sucker for Tonebenders, so I had to try this one. It will definitely go on the board. The treble/bass pot plays interestingly...

This doesn't surprise me, I don't think JBozo cares if fake stuff is sold on amazon.

184s come in three variants as far as I know, -GR, -BL and -Y There's a difference in IDSS between them. From the datasheet(RTFDS): IDSS...

I repair tube amps and radios so I'm always on the lookout to add to the stash. Inside one radio I was working on I found 2 tubes that...

Thanks, @Feral Feline and @Passinwind. I put a circuit down on vero a few days ago -- essentially what I indicated in my original post...

And I'll wager they still work.

I repair tube amps and radios so I'm always on the lookout to add to the stash. Inside one radio I was working on I found 2 tubes that...

Thanks, @Feral Feline and @Passinwind. I put a circuit down on vero a few days ago -- essentially what I indicated in my original post...

I could be wrong, and it's possibly the wrong part of the circuit to be causing your problems, but I think D1 and D2 might be in...

I finished a Chickenhead build with a few mods (after first building stock) and several socketed components: - Replaced the A10K boost...

If you can handle soldering relatively large format SMDs you can readily adapt the open source HPF board from here...

Are you planning on building it on perf/vero/self-etched PCB/gerbers>PCB foundry? Schalltechik_04 once offered the Mini-HP-Vong. I...

I repair tube amps and radios so I'm always on the lookout to add to the stash. Inside one radio I was working on I found 2 tubes that...

This was pre jumper wire. I just shoved it in the closet after working on it for hours, but will add more photos when I pull it back out...

I am a sucker for Tonebenders, so I had to try this one. It will definitely go on the board. The treble/bass pot plays interestingly...