fig
Village Idiot
What features and price point are you looking for? i.e., do you need it programmable, # of channels, resolution?
I use a Silgent SPD3303X-E and it does a great job.
Stuff
- Thread starter fig
- Start date
I use a Silgent SPD3303X-E and it does a great job.
temol
Well-known member
I have one drawer in a freezer full of various stuff - many rolls of Velvia, some Provia, Tri-X, HP5. 35mm, medium format.
fig
Village Idiot
I assembled my Psycho-Trem…initial test shows two LEDs that are not lighting, and one of those has an unresponsive pot. My guess is poor corresponding solder joints on the CD4017, so I’ll sort that bit. I did futz with the trimmers after the vid, the LEDs got brighter and the gain got gainier.
The overall audio effect is pretty groovy.
I’m using a VTL5C2, and it is functioning perfectly.
The overall audio effect is pretty groovy.I’m using a VTL5C2, and it is functioning perfectly.
fig
Village Idiot
Moving the CD4049 buffered / unbuffered saga here @Feral Feline .
I hear no true audible difference, but the proof is in the impedance if my thinking is correct. I’ll set up a 1Hz sine wave and a variable load between the circuit and the scope. I suppose I could also measure at the six input / output gate pins if needed. The pedal sounds great btw!
I hear no true audible difference, but the proof is in the impedance if my thinking is correct. I’ll set up a 1Hz sine wave and a variable load between the circuit and the scope. I suppose I could also measure at the six input / output gate pins if needed. The pedal sounds great btw!
benny_profane
Well-known member
Bummer you have to throw that board away because of that dancing resistor.
fig
Village Idiot
It needed to be on a turret anyway…and now it can be
I’ll salvage the filter caps (for another project) and pitch the rest of the board.
fig
Village Idiot
A little 2-watt single compactron amp. I was a bit reckless auditioning one with the etching rubbed off..Murphy’s Law and all you see.
Harry Klippton
Well-known member
6k11 triple triode?
steviejr92
Authorized Vendor
I’m on my way to buy a fender blues junior used haha
fig
Village Idiot
Love mine. Clean to mean…loves pedals.
swyse
Well-known member
I was thinking about building a medium power fender maybe a twin reverb but half power because my stadium is pretty small, I find fenders just take pedals so well.
steviejr92
Authorized Vendor
These guys close at 6 and the way traffic is I might have to call to make sure I get this guy he’s selling it to me for 500 I can’t let that slip….
fig
Village Idiot
Fender Blues Junior IV 1x12-inch 15-watt Tube Combo Amp - Lacquered Tweed Sweetwater Exclusive with Eminence Red White and Blues Speaker
15-watt 1-channel All-tube 1x12" Combo Guitar Amplifier with Fat Switch, Spring Reverb, and Eminence Speaker - Lacquered Tweed
www.sweetwater.com
I’ll just leave this here…warranty and all..
steviejr92
Authorized Vendor
So I just seen this…… but on another note…..Fender Blues Junior IV 1x12-inch 15-watt Tube Combo Amp - Lacquered Tweed Sweetwater Exclusive with Eminence Red White and Blues Speaker
15-watt 1-channel All-tube 1x12" Combo Guitar Amplifier with Fat Switch, Spring Reverb, and Eminence Speaker - Lacquered Tweed
I’ll just leave this here…warranty and all..
steviejr92
Authorized Vendor
Gonna try that right now gimme sec to hook everything up
steviejr92
Authorized Vendor
So I immediately I loved this setting but my strat was on the neck pickup and it filled the room with warmth but man oh man when I switched it to the bridge did this amp blow my socks off! Dude this is the best investment I’ve made in awhile besides the pedals of course haha so this is what I’ve been missing….I’ve used nothing but solid state my entire life
