Erik S

Use your meter on continuity mode to trace the path from the 9v + pad through the components of the LED path, to the switch, and to...

I cannot be sure from the pictures, but I wonder if you have the LED connected in the opposite direction.

I know it sounds like beating a dead horse, but have you verified all resistor values to be correct? It can be easy to mistake a 10K...

I solder in some bare wires to the main board sticking up, wiggle the footswitch board over them and onto the switch to solder. Bing...

Day 2 of Mike Wong's build report dump......:) This is @szukalski 's layout of Dylan159's (from FSB) PT2399 Delay. I've been pretty...

I've been sitting on this board for at least 3 years and finally got around to building it. The Abider is a well known Dumble ODS style...

I felt a little silly posting a seven minute demo for a one-knob overdrive...but I demoed less than half of the voicing options, and I...

If you've been following my somewhat irregular build reports, you'll recall the deep rabbit hole I went down (again) with the MXR Phase...

This one's for those who cry about wiring up rotary switches. 🙈 I just learned about the dead bug technique concerning ICs. For when...

I was skeptical you could hold my attention for 7 minutes demoing a one knob boost, but you did it. That’s a cool range of sounds!

This all started with @jessenator giving me the business for using an enclosure larger than his preferred 1590B. I threatened to put a...

A simple ADSR envelope generator from Guru Gara synths based on the AS3310 chip. This is the seventh EG I've built. Can't seem to get...