Robert

For example: I can't think of a commercial example at the moment, but I know there are some...

It wouldn't if it was designed for a negative tip supply.... But honestly, I can't tell... and the Wren and Cuff website isn't helping...

Are we sure it's not already adapted to a negative ground? Wren and Cuff may have flipped the circuit upside down so it'd run on a...

HEX format is text, so what you're getting is correct. BIN format is unreadable binary garbage, but (Intel) HEX is readable / hand...

https://docs.pedalpcb.com/project/Schematic-SproingDeluxe.pdf...

Yes, I drew up a through-hole version as well. You technically could do it with the Buffer/Inverter PCB in the meantime...

Are there any plans to do this in a through-hole circuit board?

I feel like you should be able to squeeze the relay bypass module under the Low Tide PCB. :unsure: The PCB shouldn't really be too big...

Updated to clarify: "With no load aside from the capacitors, those resistors aren't going to burn regardless of their value, you could...

That would be 650R from 9V directly to ground, none of the resistors in your schematic go directly to ground.... they're supplying...

https://docs.pedalpcb.com/project/PedalPCB-IntelligentRelayBypass.v1.pdf

hmmmm lemme guess....a Revv pedal?

ehx bender royale

A couple folks have mentioned that now. I'm either going to knock width down so it can fit in a 1590B or offer them both separately...