andare

I sold one for $225 and he loves it. I think this is a finicky build, the effect is subtle, but when used right it adds a lot of depth...

Heat is your friend. I think higher heat and getting in and out quickly is going to cause less damage than low heat and long contact...

You should ground every shielded wire at this point because the shield left ungrounded is an antenna for noise.

Just a thought. If buffering the input helps, it’s telling that the noise is definitely picking up noise on the input wires— buffering...

Video demonstration: Dying battery simulator - aka variable voltage regulator - aka (modded) JHS Volture. Overall circuit design by...

AFAIk you should only ground the shield at one end and that's at the jacks, where it actually goes to ground

Did you ground the shield on one side only (the jack sleeve)? Did you use shielded wire for all in/out wires on all jacks?

Shielded wire is simply wire with a metal braid around it. The braid has a lot of mass so captures the ticking and then sends it to...

This has been a few years in the making. I built most of the board before I lost some steam (and useable work space ugh) and took a...

Done.

@Robert Is it possible to merge this with https://forum.pedalpcb.com/threads/which-soldering-iron-do-you-like.16702/ So that all the...

yea thats how I feel about my current iron, takes forever to heat up and when I use a damp sponge sponge for cleaning, it seems to take...

I'm surprised with all the amps you build you don't use a chassis holder. This photo doesn't show details, it's one I built myself after...

You have to purposely misbias one mode. Turn em until it sounds bad. :ROFLMAO:

I assume you're talking about the Economy Solder Station. Yeah I would usually wait about 5-10 minutes after turning on before...