andare

Video demonstration: Dying battery simulator - aka variable voltage regulator - aka (modded) JHS Volture. Overall circuit design by...

AFAIk you should only ground the shield at one end and that's at the jacks, where it actually goes to ground

Did you ground the shield on one side only (the jack sleeve)? Did you use shielded wire for all in/out wires on all jacks?

Shielded wire is simply wire with a metal braid around it. The braid has a lot of mass so captures the ticking and then sends it to...

This has been a few years in the making. I built most of the board before I lost some steam (and useable work space ugh) and took a...

Done.

@Robert Is it possible to merge this with https://forum.pedalpcb.com/threads/which-soldering-iron-do-you-like.16702/ So that all the...

yea thats how I feel about my current iron, takes forever to heat up and when I use a damp sponge sponge for cleaning, it seems to take...

I'm surprised with all the amps you build you don't use a chassis holder. This photo doesn't show details, it's one I built myself after...

You have to purposely misbias one mode. Turn em until it sounds bad. :ROFLMAO:

I assume you're talking about the Economy Solder Station. Yeah I would usually wait about 5-10 minutes after turning on before...

I had tone of issues with that cheapo station. Mine takes at least 5 minutes to come up to temp, it has no recovery so it gets cold...

Not to derail your thread or sound rude, but there's a search function here and this specific topic has been covered with lots of...

I've only used the offset z-files. I think give you a bigger range of frets to work on and also allow you some range of how you like to...