Recent content by bilisnegra13

thanks a lot!

i have a question regarding the clippers led... both should light up? in my build just one light up and the other not

Is this by any chance, sounding close or identical to this pedal?

cool thanks ( im found this from another post you made troubleshooting Glory Hole) Measuring JFETs: Vp Connect drain to +9V. Connect gate to GND. Connect DMM between gate & source, + end at gate, measure voltage. The voltage reading will be negative i believe if i test them this way, its much...

i tried now ,lift the leads conected to Source of Q1 and Q2 from R5 and R7 and measured Voltage with red probe to S and black probe to GND in my DMM Q1 read 0.95V and Q2 was 0.75V but now, for some weird reason, i cant find the thread about the good specs for the J201 in this circuit

I just finish one unit, and didn't read this until now so i wish i could test their Vp before soldering them in the pcb. I used SMD J201's and trimpots instead of Drain resistors, funnywise i could get the bias values you mentioned here Q1=4.5V , Q2=0.5V, maybe i got lucky, pedal sound nice...

What still it would be nice to add on the schematic is the 2 leds for AB and 1 to the Y footswitch, then we will have it pretty much completed and updated I just can't wrap my head around the AB leds in order to work properly, as per the Y led part is easy, since there's just 1 led ...

Sure

I just notice this trace after finally remove those switches

Thanks for all the input and sorry for the late response So I made a sch on my newbie skills and so it looks like right now, it's messy but somehow I followed the layout trace, I'm sure there are better ways to put a sch down Anyone could add the 2 leds for the ab and one led for the both...

Ok ok

The traces are shown on the pictures with the red, black and blue traces, the real foto is just to show the transformer Basically on the other side of the actual pcb you can just see the traces what are the red lines on the draw pcb

Hello folks I need a reverse engineer, tracing master Since my skills for doing schematics from scratch are bad I come here and ask if anyone can help with that, plus checking if all connections makes sense and to see if anyone can find the transformer substitute for this one since typing the...

Great builds, are you selling those pedals or pcb's?

Di you try to swap all the 470n caps for 680n as per in the original Armageddon? Curious if you compared your build to the videos in YouTube where Oliver show his pedalboard and use the Armageddon?