Brett

This has been a few years in the making. I built most of the board before I lost some steam (and useable work space ugh) and took a...

do you have another circuit that you could test your clock and BBD chips in just to make sure they are good? And since it is always a...

I did a 125B-sized PCB that was a lightly-modded Boss OD-1 circuit into an OCD circuit and it sounded *awesome*; since...

Is the pop better/worse in any particular position? You may have some dc leaking across the caps which could be a likely culprit.

Which Rangemaster do you have? Do you have a schematic?

Also, one of the benefits of bending the leads for me is that I don't have to have the iron out to populate the board. I populate a...

Man this one sent me down a fun rabbit hole. Based on this thread I did buy some orange masking tape but "PCB assembly jig" or "pcb...

Gross. If a circuit board design depends on the use of electrical tape in order to work properly, it probably shouldn't be a commercial...

Populated according to the build doc, except there's a 1.5k stopper between lug 1 of the Harmonics pot and ground. Box is by Scientific...

Do you have any of the other 3 working builds handy? Can you check the voltages on those with your voltmeter to see if the voltages on...

Hey there @red, I'm pretty sure you're going to hear a loud noise any time you disconnect the output cable of a pedal if that cable is...

Because the component values are printed right on the pcb. And this is diy. And calm the fuck down. Jesus…

Do you have children? I think you are about 10 years old. Go learn some courtesy.

I know I say this every time I see one of your builds, but this one looks so good inside and out. Lots of nice touches, like the metal...

My bad, I just assumed it was the drain resistor.