Coach_McGuirk

Good call. This helps a lot. Much more use from the volume knob now. Thanks.

Really though, the reason it works is when you make the TeePee, all those DEVO Energy Domes combine forces to protect your build by...

Use an a100k (audio/log taper) pot instead of the b100k (linear taper) pot for the output volume Will give you the control you need (I...

R21: 12k R22: 4.7k Maybe I'll just stick two trim pots in there? Can I adjust one and not the other, or do they need to remain balanced?

This pedal is far too loud for me. I would like the volume knob to be more operable. What can I change in order to help reduce the output?

The other side is the switch itself. Also, there's much less clearance on the other side, I think.

I don't know what "relatively cheap" is these days but if you're a buy-once-cry-once kind of a person, a BF Princeton Reverb is the...

I see now. You're right.

Worked great! I suppose this could have been done with a single resistor, but I dig the tepee thing. I hope @Robert implements this...

I guess the easiest way migh be to put them on the solder side, between pins 1-8 of the switch and ground. Maybe arrange them like the...

Oh, forget what I said about maybe deleting R1 and using 1Meg pulldown resistors. Not a good idea. I thought too fast. Keep R1 and try...

Looks like the cleanest way would be to hook the pulldown resistors to the 8 lugs of the switch, bend them all over into a "tent" and...

How do you wire it to be parallel and series?

I'll throw in the Way Huge CamelToe combo I built: TS --> Red Llama. Mine has diode selectors and a "working" series/parallel switch.

Thanks, this looks like the answer! Any tips on adding these to the board?