Cybercow

If the fuse is good, I'd start with a full recap of all the electrolytics and any tantalums (didn't see any pants in the photos). As...

Yes I believe so. We argue about guitar effects pedals here. There are probably a few procreate users here but it's far from a...

Any chance of adding an EasyEDA sub-forum to the PCB design area? There are a lot of classic bits that may need parts / templates for...

So look, did I ever mention that I have a problem? ... I pre-ordered one shortly after this thread popped up... then I got impatient...

Not amused. Spray paint and goop? This was a really nice looking pedal otherwise. So disappointed in that decision.... This is...

Well, I don't know the riff, but ....

Should be 2 - 3 weeks I reckon. I'm going to go ahead and order a bunch of the transistors today and have those ready.

I imagine it will be a few years months weeks before these are available?

You'll have to goop it yourself. I also added polarity protection and a filter cap but you're welcome to omit them both and live...

It's a modified Boss Tone, as suspected.

Maybe that’d be a nice idea for a new pedalpcb utility board (pot->trimmer)

Those would work nicely for the "Soft" control, but the "Tone" control needs all three leg of the trimmer.

Use the LEGACY PCB, and you can just make the 9mm pot a 9mm internal trimpot mounted on the component side (it'll rotate backwards, but...

Pedalpcb has a Trimmit board for this exact purpose ($0.50). I’ve also made similar board out of stripboard.

I had great fun researching and building this one. The new board design does an even better job at fueling your ADHD by not including...