Recent content by Dirt_diggler

Did this wiring diagram work for you?

i will be using a 3rd 3pdt switch to be able to switched the order of the 2 enclosed pedals.

So I'm planning to combine an old 90s ts9 with a kliche mini inside 1 single enclosure using 1 DC jack and 1 pair of i/o jacks. I'm having a hard time understanding how to wiring up a 3pdt toggle switch for order switching of the chain. The kliche mini is buffered bypass. The old ts9 uses a...

Sorry to revive an old thread but o was curious if this means the middle row/outer lugs of the switch are just left alone? So the positive from in and out jacks go to the board instead of the switch?

Thank you for this answer. So just to clarify, treat in/out on the board as the in/out wires going to the order switch board?

I'm actually wondering now if the foot switch is wired to the board like normal but then i use the in/out holes from thekliche PCB directly to the order switch board?

Hello, i am using an order switch with a pauper and kliche mini for a 2 in 1. However i was having trouble understanding s1-s6 on the switch holes on the kliche PCB side. I usually see in/ground/switch/out for other PCB to switch then the switch has a separate wire to in and out respectively. I...

thank you! just ordered one. looking forward to this silliness.

So I was measuring up my 1590BB and realized because of the placement of the right angle pots, it places the boards with no room for the footswitches. I am wanting to combine a pauper and kliche mini with an additional toggle to change the order of circuits as needed. I really only know the...

Looking at the bill of materials I'm confused about the 20uf electrolytic capacitor. For some reason i can't seem to find a 20uf and it brings me to giant appliance parts. Is there a typo here? The only thing remotely similar was an axial lead 20uf cap i found...

Bypass works as it should and both sides of the pedal work if it's completely outside the enclosure. When it's in the enclosure, no lights turn on. Again, the only time any problem persists is when the OUTPUT jack is touching the enclosure. When that happens. Nothing works. Not even LEDs

Ah ok. I thought that's what you meant. I know it by other names. Sorry about that.

What do you mean audio terminal?

Honestly I wasn't paying attention to the LED behavior so I will check that tonight. But I'm almost certain they do not light up when it's shorted. I can tighten down the pots to the enclosure and still play it with the jacks outside the enclosure. When I let the output jack touch the...

Im starting to feel like the output ground port on the pcb has something going on with it. I may jumper ground from the input Jack tonight and see if that could be the issue.