flemming

I've had a Prusa MK3 for years now and it's as close to "it just works" as I think you can get. Not the cheapest, but what's your time...

I may be a slightly out of my depth here, but looking at the schematic, the sweep switch has 9v coming in on the "A" pins, so if you can...

Maybe, up/down mode changes might require you to tinker with the cutoff point. I still want to play with this a bit more. From my...

Nice, I just tried this out real quick as well and I think it certainly helps bring more range. I grabbed ~9v from pin8 of the same...

Another board that was generously sent to me by @fig! Thank you to @Chuck D. Bones (circuit design), @cooder (PCB design), and @fig...

This board was generously sent to me by @fig along with a couple others (those build reports will be soon to follow). Thank you to...

I now realize that I think your problem is with a different pedal and that you just popped into this thread since it seemed similar. You...

My Tyrian whistled like crazy until I used shielded wire for the input jack.

I prefer pale ales these days. I’m a bit over the whole ipa fad.

New demo, lots of pedals used....the rest is TL;DR......feel free to skip....:p A few months back there was a thread where we were...

I put the lock washer on the inside, white washer in the garbage, metal washer on the outside, and then tighten the nut

One side should be grounded. Be careful that on the non-grounded side you don't have any tiny pieces of braid exposed that could short...

It is, without the shielded cable it screeched and whistled like crazy. I didn't have any shielded cable on hand at the time so I just...

I haven't played with the loop too much. The docs talk about putting your input signal into the loop return and then adding something...

I bought then from smallbear before they sold. At the time they listed the MCD value, but now I don't see it. I think the ones from...