Recent content by FloydianPulse

  1. F

    El Sol Distortion No Sound - Audio probed

    No, pcb is stock, I didn’t file anything since it fits as is. I have another pcb, might see if those traces are continuous on that one before I populate it.
  2. F

    El Sol Distortion No Sound - Audio probed

    Stuck a piece of thick paper just in case any of the circuit board touched. Snow cones to beat the heat from this puppy!
  3. F

    El Sol = 125B 1-KNOB (TYPE 1) ?

    Wasn’t easy but got it all in there!
  4. F

    El Sol Distortion No Sound - Audio probed

    Yeah, that did the trick, guess I should have been able to figure that one out on my own. Shame to have the cable but works perfect now. Thanks!! Confirmed, can build her into a 1590A, not super easily but she fits!
  5. F

    El Sol Distortion No Sound - Audio probed

    Here’s the footswitch connections.
  6. F

    El Sol Distortion No Sound - Audio probed

    Input wire, I know that looks bad but connection is solid, I just didn’t cut it away. Pedal passes audio through when bypassed perfectly.
  7. F

    El Sol Distortion No Sound - Audio probed

    Hi all, I built the El Sol and squeezed it down to a 1590A and the LED works great but no sound is coming out of the pedal when activated. Bypass works fine. I used an audio probe and found the following: Any ideas where I should go next? While activated, the red circles have no sound, and...
  8. F

    El Sol = 125B 1-KNOB (TYPE 1) ?

    I’m gonna try to squeeze into a 1590A mini housing. Will see how it goes...
  9. F

    Special Overdrive transistor question/mistake

    About to build this circuit and realized that I bought BC548 instead of B or C, looking at data sheet seems the unlettered one just has a wider gain potential. Since not being used as gain am I ok to proceed with the unlettered BC548?
  10. F

    Paragon L/H Gain Toggles

    Thinking of running all high gain in sockets or a trimmer, haven't decided yet. Any thoughts on how to wire a couple of 3-way toggles to the 4-dip switch PCB ports so that you could select them Boost/OD/Dist? Basically, Boost is (Down Down), OD is (Up Down), Dist is (Down Up). I'm not exactly...
  11. F

    Paragon L/H Gain Toggles

    Yeah sockets are probably the easiest and best option. Was thinking about a trimmer but wasn’t sure how rigid the spec is on either a 1K or 100K for those resistors. Thought an external toggle might be kinda sweet.
  12. F

    Paragon L/H Gain Toggles

    I’m indecisive about low or high gain, initially thinking to do side 1 as high and side 2 as low when I thought about wiring a 100k in parallel on 2 spdt toggles for each side. Anyone done this or have any advice on the best way to wire it?
  13. F

    LED Positioning

    Do I have to bypass the pcb resistor if I go DC to SW?
  14. F

    LED Positioning

    I have an LED housing with a resistor in it already with an anode and cathode line. In your Vero board example that is similar, where would you connect those lines to a standard pedal pcb board if the board already has the 4K7 installed? I was thinking I could connect the lines to A-K and run a...
  15. F

    LED Positioning

    But how do you wire that? Essentially I just want to run a separate LED with a prewired resistor and not use the primary LED pcb slot.
Back
Top