Recent content by forumimagedemarque

thanks @darwin999 !

The idea here is to run it through 2 amps. Should I be concerned about anything ?

@Robert is your approval a Yes ? :) Just wiring the 2 outputs identically ?

Hello there, Have try to do it ? I'm currently building one myself and I really d'like the second output. I've seen a gut shot of a original one and it looks simply like both output are wired the same. Anyone has hint on this ? Thanks !

Super interested by this subject actually. Love The Chicken Head but find it pretty hard to produce more then one that'll works ok. Due to finding the right transistor. So you're saying that I could just replace the germanium transistor in this circuit as long as it's low gain (I suppose around...

I finally found the problem :) One of the resistor between R12 & R15 was fried. Replace all 4 for of them and now it's working perfectly. You where right there is plenty of volume after noon :) Thanks @MichaelW !

Thanks man ! There is definitely a problem in my build. I'm investigating.. :D

I measured, I swapped the pots and it's not it :( Problem is still there. I'll try to probe maybe.

Thanks for all the good advice Michael :)

Thanks, that could be it absolutely ! I'll try to swap it :)

Can I ask you a little question about the curve of the volume pot ? Mine seems to be slightly under Unity before 3 o'clock and then boost much after it. Is it a normal behaviour or did I made a mistake somewhere. I was thinking about replacing the Log Pot by a Lin. Thanks for your input.

Nice build ! I just build one myself. Something that I'm curious of : Do you get a volume boost after 3 o clock on the volume Knob ? My build seems to work ok goes much louder avec 3 on the volume.

Hello there, Just giving my little feedback on this topics. I was also finding that the Electrovibe had a low output level. Then I found your thread and tried to swap the R4 - 47k to higher value. Experimented with a 1M Pot, which I found still too weak. Then with a fixed 2M resistor : this one...

Perfect. It's possible to make square hole with the tayda cutting service. I'm gonna stick to the square on the PedalPCB template then :) Thank you !

@swelchy Can I ask you one last thing about that toggle switch if you mind ? What was the size of the square hole to install it ? Did you follow the ref from the drilling template from pedalpcb instructions or did you cut it based on the datasheet of the toggle switch ? I'm considering having my...