Recent content by Giorfida

Why do I keep saying the name of that in Rick James voice?! I could see this being a super useful pedal to have!

I’m lazy and need to get on them! I’m notorious for never fully completing anything. I build it, test it, box it up and throw knobs on it. By the time it comes to labels and build reports, those seem to never happen. If you add up all that I have here now, I’m have around 50 completed...

Nice build Just did one myself a couple weeks back, also thinking it was an easy day…wasn’t. But for me, the big time sink was trying to use 1/4w resistors Honestly don’t know why it’s taken me this many years to really try one!

I was wondering if you would get these or the Peavey pedals first

They do…and trust me you want to use it! The way they stage some of the solid state components in the amp, you will get some nasty clipping before the power tubes start really work if I remember correctly (of course that may vary depending on revision…the one I had was the grey rug covered...

I’m also a big fan of the “double points” days… especially when they fall on Sundays- always the quickest times in and out of the “grocery store” My bets are that Robert’s accountant must have voted Niiiiiceee!!! Did I miss some good drama? Trip to Cancun? I’m just happy to get enough points...

You could absolutely use the od250 board. Other than a few component changes (and only using 1 lnob and not 2), the circuits are nearly identical. In fact, Tonepad and some others sell the same Board to do the Distortion+, OD250, and MicroAmp and just list the part differences in the BOM

nice!! After seeing how cool that build looks…and reading the documentation on it (thank you again!) looks like I’ll be adding yet another to my “to build” queue!

Thank you!

Definitely a fun build!

Is there some documentation here or elsewhere on how to set the limit washer proper;y?

Agreed on all points. And you bring up a good point- in the champ topology, it definitely is power tube being driven, where in most push pull amps, the phase inverter acts as a limiter and breaks up while keeping the power tubes from clipping. But simple amps like this have so much room to...

Dude! Great job!!! I definitely hear the super bass/jTM vibe going on. You are right a bit of NFB will help take out some of the harshness. Others you won’t get out- there is just a bit of magic that the cathode follower, long tail PI and push pull output do that we can’t “naturally” get...

Damn! Wish I would have waited a bit before building the “Face Melter” drive!

Keep posting updates! Sounds like a cool idea!