Recent content by greypilgrim76

So just a quick update. I took the PCB out of the enclosure, attached it to an external power jack, and started through the circuit with my audio probe based on the schematic and component diagram you guys provided. I actually managed to get sound all the way to the output jack, which convinced...

Not yet--I just finished it before dinner last night, and when it didn't work, I just put it back on my work bench for the next time I've got a chance to work on it. I'll post some pics when I dive back in!

Thanks, Robert! I was ready to roll my sleeves up and just start poking around, but this will make it about 1000x easier!

Nice! Not sure how I missed that. That schematic should get me a lot further down the troubleshooting road. I don't suppose anyone has the PCB image with the components labeled using R2, D1, etc.? I can use the image of the PCB itself on the website with the component values themselves, but...

Hi All, So I just got my Pro-10 board populated and (very tightly) installed in the enclosure. When I plug it in, both LEDs work, and I'm getting bypass signal, but no sound from either side engaged. I've got an audio probe and am happy to start troubleshooting, but I can't seem to find a...

No worries--I did ask! :) And yeah, I basically built this for two reasons. First, because I just love both of these pedals and have been playing around a lot with stacking overdrives. Second, because I looked around and couldn't find anyone actually doing it already. I figured if I was going to...

Good to know! I don't remember it from my Boss pedal, but I also haven't played it in a while (or that much overall), so it's good to have confirmation that I didn't screw anything up! :)

So some of you knew I was chipping away at this one because I had to keep asking wiring questions, but here's my latest effort. I call it "Klon Sung Blue" because I'm a dork and also a Neil Diamond fan. Anyway, it's the Notakliche on the left side and a Blues Driver on the right side, with the...

Okay, this is super-helpful! The only difference is that my enclosure is drilled for the pcbs being on the opposite sides, but I'm assuming in that case that the Notakliche's "IN" would just connect to the breakout board's "S2" instead of "S1," and then likewise with "OUT" going to "R2" instead...

A follow-up question. I'd forgotten that the Notakliche has its own special breakout board and the in, out, and ground are routed to the top of the board: In this configuration, I'm assuming that I just send one of the ground pads to the ground tab on the audio jack on that side of the pedal...

See, this is the quality content I come here for. :) I feel like I'm starting to get a clear sense of how grounding works, but I didn't realize all of the grounds are connected. (*Reminds self for 100th time to always check schematic before asking questions*)

Ah, I was this close. :) So then, would I just leave the left ground tab on the right-side pcb and the right ground tab on the left-side pcb empty? (I'm guessing that those are both used on a normal single pcb setup to complete the ground, but here it's being completed elsewhere?)

So if I'm reading this right, it would look something like this? (Or am I misunderstanding? Always a possibility!)

Quick question. I'm getting ready to start on my first two-pcb-in-one-enclosure project (combining a Blues Driver and Notaklon), and I'll be using the 3PDT Order Switch breakout board for the first time. The wiring diagram on the switch page is great for layout almost everything out: But, the...

Many thanks!