Recent content by Iceman53

Thank you as well! Great work you're doing here!

Great! Thank you!

Wait...how are you referencing actual part numbers, like C7, R8 etc. if there are no build documents on the pedalpcb ADHD page?

Thanks. That's good info. I'll try a few of your suggested changes.

I wasn't really trying to recreate a specific version. It's just that my Fulltone V1.3 sounds better than the latest pedalpcb version to me. I'll try pulling the Germs. Thanks for the help/ Appreciate it.

Can you post a link for that wire please? I'd like to try that instead of stranded.

To clarify, I just built the 'new' Pedalpcb ADHD version (https://www.pedalpcb.com/product/pcb542/), using the component values shown on the pedalpcb circuit board, since there are no build documents listed yet, and no schematic. MY Fulltone OCD is a Version 1.1, the first one they made. current...

I just finished building this 'new' version, and I need to pick your brain a little, if you don't mind. So, I used the component values on the picture of the circuit board, and 34a's for the diodes. It works, but it's a little on the 'trebley' side, with not a lot of bottom end. If I turn the...

Thanks for the wire suggestion. I just ordered that, after spending way too much time trying to stuff 22ga stranded through the tiny pcb holes.

I'm pretty sure the tinned wired is not the source of your 'noise' issue. My 2 cents...

Thank you!

There's a mini-slide switch on the ADHD page, like it might be an option, but I don't see a spot for it on the circuit board?

thank you

I have a question about using a socket... does elevating the reverb module a little higher, because of the socket, affect the mounting of the pots, switch, jacks, etc?

Thanks for the quick reply. It's doing what I need it to do. Good feedback on the Clandestine. I'll try that next!