Recent content by JUSS10

thank you! any clue which caps are the tantalum ones? @Robert

is there a component list for the micro amp plus that just came out?

do you have the component list somewhere? my PCB should be in the mail today and I want to order components.

Yeah… got lucky as I didn’t do a great job laying the rear panel out but in the end it worked. Would maybe use a smaller diameter jack in the future or side mount it.

Pretty sure this is a BBS enclosure that I got from stomp box parts

I have a DBA rooms and pulled it off myself just to confirm it works.

Finally finished this pedal after I had the PCB populated for the last month. Seems like I got it together properly without a build doc. I have my inputs tied with a switching jack on one of the inputs so I can run mono or stereo in. Left it set as independent stereo outs. Not sure if I want to...

that was my plan. I see that there is already a terrarium library which should help. Has anyone put together some sample builds for the terrarium in C++? I have found a few terrarium specific effects on github. Maybe its best to take that code and reverse engineer?

I'm fairly competent with arduino so I have installed the DaisyDuino Library in the arduino IDE. I've also gone through all the steps of installing Visual Studio code and have been able compline and flash the blink demo there. Also I've looked in to Pure Data but haven't gone to far down that...

Built up a Terrarium. Happy with how it turned out. I’m dumb and ordered a 3.3v regulator instead of a 5v so got to get one of those. Otherwise it was an easy build. Even drilled a hole in the side to access the USB port so I don’t have to pull it out to program. Now if I could just get my...

Yeah those are the female headers I got. The 1st box caps are still too tall for it to go all the way in. May use MLCC then.

so the board layout looks like you are supposed to use the larger box film caps but those prevent the daisy from sitting all the way down in the header. Can I use MLCC 1uf caps in place of the 3 box caps on the board? Thanks!

@Robert is there a component list somewhere? I’m assuming once the boat. Gets delivered the components will be marked on the board, just thought I’d place an order for parts while I wait for the board to show up. Thanks again!

Order in! Thank you so much @Robert!

So as per usual with me, I kind of dove in head first on this FV-1 stuff. I have built both the arachnid and the dev board. I wish they were one and the same where I could have a programmer on board but also access all 8 programs. I decided to prototype a mini C341A programmer that I could...