Recent content by Kelmark1

Hi, buildt older version of circulator phaseer with , the 3 leg (dual) led. Is the schematic still available here somewhere? Ray

mines doing the exact something, chip it getting very hot, your ended up being a grounding problem, I put a good coating of electrical tape on my dual gang pot, I used a TC1044s instead of maxx chip but both get hot

nice build, what LDRs did you use for your build?, i have the typical tayda LDR on hand and some left over GL5516,, think their useable?

thanks, did you use one from tayda?

waking up a old thread...did anybody ever find where to get a 4PDT footswitch that fits the PCB spacing on the twin face board ? have a couple 4PDT switches I had on hand from tayda but lugs don't quite fit the PCB....

how do you like your Quaverato ?, I've been think about building one.

thank you

I don't see these on tayda, do you know if they have them or not, only see female, sorry to be a pain

great, thanks

so I can put this to sleep, the long lead on the LED side goes closest to the edge of the board?

I've been least happy with mine, (sputterly/gated sound) , So you recommend MMBFJ201 N-Channel JFET Transistor setup sold here on pedalpcb or the Siliconix J201 ? Where can i get the Siliconix J201's from?

Thanks

Bugg, do you sell the board by itself, looked for it but couldn't find it, so maybe you don't, thanks

Looking very sharp, how do you do your boxes? Spray paint them and then what?

I just got done with a dual led build That didn’t work; the green side barely come on, would it be worth ordering another or should I invest the time troubleshooting the dual led one? Ray