Recent content by ninemag

  1. N

    Help with transistor id

    That make sense- thanks for clearing that up-
  2. N

    Help with transistor id

    What is the deal with these transistors? Do they come with leads like this? Or are the leads soldered on AMS the cap covered for aesthetics?
  3. N

    Tone Vendor MK2 NPN

    You had, thank you!
  4. N

    Tone Vendor MK2 NPN

    Is it possible to run NPN transistors in this? any way and or need to bypass the charge pump? Thanks! Jeff
  5. N

    Thermionic oscillation issue

    Good idea
  6. N

    Thermionic oscillation issue

    Went through it again- checked out the trimmer and it looked like it had bent a little and maybe was contacting where it shouldn’t- replaced it. Tested all pots, all normal. Sound is better, but still getting the feedback oscillation. I CAN make it go away when I turn back the “tight” knob, I’d...
  7. N

    Thermionic oscillation issue

    Hooked it up with no input- footswitch off. High pitch hum still there. I replaced the footswitch and rewired the connections to the board/jacks. No change. Looked under magnification but nothing looks obvious
  8. N

    Thermionic oscillation issue

    Trim pot lowers it, but it won’t remove it. Did some more troubleshooting- I can hear it when the pedal is off; very low, but I can hear it in the dry signal. And even in the dry signal with no power to the pedal, the gain and tight knobs change the pitch of the oscillation. I’m thinking it’s a...
  9. N

    Thermionic oscillation issue

    I believe so
  10. N

    Thermionic oscillation issue

    Just finished this build and it’s acting funny... It’s making a feedback/oscillation. More accurately an oscillation that sounds like feedback- when I adjust the gain, tight, and trimmer, they affect the pitch and intensity of the oscillation. Any ideas? Posting pics Thanks for the help-
  11. N

    Propolis/bumble buzz resistor

    Thank you guys very very very much! Great info.
  12. N

    Propolis/bumble buzz resistor

    I’m working on a bumble buzz and don’t ha e any 1k8’s... can someone give me an idea of what these are affecting in this circuit? I’d like to understand so I can experiment, or wait for the tayda order lol. Got lots of 1k5’s and 2k2’s
  13. N

    Propolis Fuzz diode question

    Thank you- I looked at the schematic, and it looked ok to swap, but I appreciate the expert advice. Added a bunch of 4007 to my Tayda cart... pretty darn cheap lol
  14. N

    Propolis Fuzz diode question

    Realized I don’t have any 4007’s. got lots of 4001’s, 5817’s and 5817’s. Any of these make a good replacement?
  15. N

    Power loss when cord plugs in

    Thank you! I’ll check it out
Back
Top